Before you install
Confirm the following with your site communications administrator:
- TCP/IP connection type: TP0 to an HLC, DCP as an IP router, or Host Gateway Server (HGS)
- IP address of the host, DCP, or HGS
- CMS Process or Telcon XEU values for DCA TS and HLC/router (e.g. RSDCSU for DEMAND)
System requirements
- Approximately 9 MB hard disk space for the PC client
- A current supported version of Windows
- Winsock-compliant TCP/IP stack
PC component setup
- Insert the InfoQuest setup media (or run the downloaded installer)
- Follow the on-screen instructions; accept the defaults whenever possible
- After install, launch InfoQuest and run the WinQ UTS Configuration utility to set the connection
Host component installation (Unisys 2200)
InfoQuest runs ad-hoc reports through Q-LINK on the host. Make sure Q-LINK and its supporting subschemas/views are installed and that the user-id used by InfoQuest has access to the Q-LINK transaction.
- Install Q-LINK on the host using the standard COMUS local install procedure
- Configure the Q-LINK TIP transaction (CMS Process or Telcon XEU) and grant access
- Verify connectivity from the PC with WinQ UTS Configuration before launching InfoQuest
Note: InfoQuest does not require knowledge of the underlying file structures, but the host-side Q-LINK installation must be completed by your DBA or site communications administrator.